f. Interface definition.
1.3.5.2
Operator's Manual
The operator's manual shall fully explain procedures and instructions for
operation of the system.
1.3.5.3
Maintenance Manual
The maintenance manual shall include descriptions of maintenance for all
equipment including inspection, calibration, periodic preventative
maintenance, fault diagnosis, and repair or replacement of defective
components.
PART 2
PRODUCTS
2.1
RADIO FREQUENCY COMMUNICATION EQUIPMENT (RFCE)
2.1.1
General
All equipment need for a complete two-way radio system for wireless data
transmission from building to building (point-to-point) for the utility,
monitoring and control system (UMCS) used to extend the Ethernet shall be
provided. The two-way radio data transmission system shall consist of
wireless bridges, [hot standby protection switch], communication links,
antenna systems, communication links surge and overvoltage protection, and
powerline surge protection.
2.1.2
Government Furnished
**************************************************************************
NOTE: Designer must identify Government furnished
RFCE. The Government may supply the use of existing
suitable geographical location.
**************************************************************************
The Government will provide RFCE as indicated. All government furnished
equipment shall be tested by the Contractor to assure that the equipment is
in calibration and functioning correctly. Modifications to the
Contractor's system shall be compatible with the government furnished
equipment.
2.1.3
Contractor Furnished
**************************************************************************
NOTE: Designer to select which components of the
network are Contractor furnished or Government
furnished.
A.
The designer must determine if there is line of
site
between the point-to-point bridges. If not,
then
the designer must utilize antennas to create
line
of site.
B.
The location where the point-to-point bridge or
antenna is located may already contain RF equipment.
If this is the case, band pass or band reject
SECTION 16798A
Page 10