1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
INSTITUTE OF ELECTRICAL AND ELECTRONICS ENGINEERS (IEEE)
IEEE C62.41
(1991; R 1995) Recommended Practice for
Surge Voltages in Low-Voltage AC Power
Circuits
IEEE Std 142
(1992) Recommended Practice for Grounding
of Industrial and Commercial Power Systems
- Green Book
NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA)
NEMA 250
(2003) Enclosures for Electrical Equipment
(1000 Volts Maximum)
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
NFPA 780
(2000) Installation of Lightning
Protection Systems
U.S. FEDERAL COMMUNICATIONS COMMISSION (FCC)
FCC Part 15
Radio Frequency Devices (47 CFR 15)
U.S. NATIONAL ARCHIVES AND RECORDS ADMINISTRATION (NARA)
47 CFR 15
Radio Frequency Devices
1.2
SYSTEM DESCRIPTION
1.2.1
General
**************************************************************************
NOTE: Designer must show location of radio
frequency (RF) equipment to be controlled. Designer
must also show any Government furnished equipment
(GFE). A standby bridge and hot standby protection
switch may be required for critical areas.
**************************************************************************
A two-way radio system for wireless data transmission from building to
building (point-to-point) for the utility, monitoring and control system
(UMCS) used to extend the Ethernet shall be provided. The two-way radio
data transmission system shall consist of wireless Ethernet bridges, [hot
SECTION 16798A
Page 4
Previous Page
