NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
NFPA 70
(2005) National Electrical Code
U.S. DEPARTMENT OF AGRICULTURE (USDA)
RUS 7CFR 1755.900
(2000) Filled Fiber Optic Cables (REA)
U.S. DEPARTMENT OF DEFENSE (DOD)
MIL-STD-188-176
(Basic, Notice 1) Standardized Profile for
Asynchronous Transfer Mode (ATM)
MIL-STD-2042
(Rev B) Fiber Optic Cable Topology
Installation Standard Methods for Naval
Ships
1.2
RELATED REQUIREMENTS
**************************************************************************
NOTE: Coordinate with Sections 16302N UNDERGROUND
TRANSMISSION AND DISTRIBUTION, and Section 16145 480
VOLT PIER POWER OUTLET ASSEMBLIES. For
LANTNAVFACENGCOM projects, use Section 16303N
UNDERGROUND ELECTRICAL WORK in lieu of Section
16302N UNDERGROUND TRANSMISSION AND DISTRIBUTION.
**************************************************************************
Section 16050N BASIC ELECTRICAL MATERIALS AND METHODS applies to this
section with additions and modifications specified herein.
1.3
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
SECTION 16713N
Page 6