and Rubber Insulating Tape
UL 514A
(2004) Metallic Outlet Boxes
UL 6
(2000; Rev thru May 2003) Rigid Metal
Conduit
UL 6A
(2000; Rev thru Jan 2004) Electrical Rigid
Metal Conduit - Aluminum, Bronze, and
Stainless Steel
UL 773
(1995; Rev thru Mar 2002) Plug-In Locking
Type Photocontrols for Use with Area
Lighting
UL 773A
(1995; Rev thru Jul 2003) Nonindustrial
Photoelectric Switches for Lighting Control
UL 797
(2004) Electrical Metallic Tubing -- Steel
UL 83
(2003; Rev thru Mar 2004)
Thermoplastic-Insulated Wires and Cables
UL 854
(2004) Service-Entrance Cables
1.2
RELATED REQUIREMENTS
Section 16050N BASIC ELECTRICAL MATERIALS AND METHODS, applies to this
section with additions and modifications specified herein.
1.3
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
SECTION 16522N
Page 11