g.
Four one-quart containers of paint for outside finish.
h. One portable test set by the same manufacturer as the static trip
devices to check the operation of the static trip devices without the
need for high primary circuit current.
i.
One indicating lamp replacement tool (if required).
1.6
SPARE PARTS
Spare parts shall be duplicates of the original parts furnished, and shall
be interchangeable therewith. The following spare parts shall be furnished
for each type and frame size of drawout circuit breaker, except that only
one spare is required where parts are applicable to all types and frame
sizes of the circuit breakers:
a. One complete set of main, intermediate and arcing contacts and
associated springs for one three pole breaker.
b.
One complete set of arc chute assemblies for one three pole breaker.
c.
One set of primary disconnecting devices for one three pole breaker.
d. One set of secondary disconnecting devices for one three pole
breaker.
e.
One shunt trip coil.
f. One Spring-charging motor or solenoid for electrically-operated
breakers.
g. One Control relay of each type and rating for electrically-operated
breakers.
h.
One Auxiliary switch complete for electrically-operated breakers.
i. One manual operating mechanism handle for drawout feeder air
j.
Twelve fuses of each type and size for voltage transformers.
k. Six Indicating lamp assemblies (three red lens and three green
lens.)
l.
Ten Indicating lamp color caps of each color.
m.
One spring for stored-energy closing mechanism.
n.
Four spare blank nameplates for operating unit doors.
o. One lot spare bulbs for indicating lamp assemblies, package to
contain not less than 20.
PART 2
PRODUCTS
2.1
COPPER AND ALUMINUM BARS AND RODS
Copper or aluminum bars and shapes for main bus and ground bus conductors
may be provided at the option of the Contractor and shall conform to the
SECTION 16404A
Page 14
Previous Page
