An analysis to verify that the motor, when operated in
accordance with the duty cycle specified, will not undergo
injurious temperature rise. If the duty cycle cannot be met with
a standard NEMA design motor, the motor manufacturer shall provide
a description of proposed modifications to provide such compliance.
Motors[; G][; G, [_____]]
[Six] [_____] copies of complete descriptive specification of
each type and size motor provided, with necessary cuts,
photographs, and drawings to clearly indicate the construction of
the motor, the materials and treatments used to prevent corrosion
of parts, bearing construction, and type of insulation used on all
windings. Submittal shall include all information required for
selection of protective and control equipment and for operational
setting, such as, but not limited to, normal and maximum operation
temperature for windings and bearings, overload trip setting for
motor at pump maximum head condition and starting times for
starting at rated and 90 percent starter voltage. Contracting
Officer's approval shall be obtained in writing prior to the
commencement of manufacture of motors.
Government Study
[Six] [_____] copies of the specified data.
Spare Parts
[Six] [_____] copies of a complete list of renewal parts with
prices for each different rating of motor. This list shall
accompany the instruction manual.
SD-06 Test Reports
Starting Capabilities
[Six] [_____] copies of certified test reports, when available,
of tests previously performed on motors of each type and size
specified or calculated data to substantiate the motor's
capability to conform to the specified requirements.
[Six] [_____] copies of test reports recording all data obtained
during the tests specified shall be provided to the Contracting
Officer for each motor used. Test reports shall include
performance curves indicating the results of paragraph COMPLETE
TEST. The base value shall be given whether ANSI or IEEE standard
system is used.
SD-07 Certificates
Power Factor and Efficiency
Certification of guaranteed value of power factor and efficiency
for full load, 3/4 full load, and 1/2 full load.
SECTION 16221A
Page 6
Previous Page
