Engineer's Qualification Resume

1.5.2

Submit a printed certified qualification resume of the engineer or

technician to the Contracting Officer. The engineer or technician's resume

shall list applicable experience related to installation, start-up and

testing of equipment and applicable factory training and education.

Qualifications require the engineer to have supervised two installations of

similar size and type which are operating satisfactorily. More than one

engineer or technician may be provided based on the types of specific

equipment. In event more than one engineer or technician is provided,

provide a certified resume for each one and indicate his specific specialty

and item of work on the resume.

1.5.3

Start-Up, Testing, and Installation Engineer

The Contractor shall provide the services of a qualified engineer or

technician for start-up, testing, and installation of equipment as

specified under paragraph entitled "Qualifications of Engineer." The

engineer or technician shall be an employee of the equipment manufacturer.

1.5.4

Installation

Provide an installation engineer or technician to install and supervise the

installation of steam boiler system including instrumentation and boiler

controls. Provide the technician or engineer until equipment installation

is coordinated and completed with checkout.

1.5.5

Start-Up Plan

Submit a written schedule with dates of start-up, test, installation and

checkout of equipment to the Contracting Officer.

1.5.6

Start-Up and Test

The specific equipment tested

shall be the boiler, boiler controls, boiler

instrumentation and feedwater

equipment. The start-up and testing engineer

or technician shall remain on

the job until the unit has been successfully

operated for [_____] days and

the unit has been accepted by the Contracting

Officer.

1.5.7

Start-Up Certification

After installation of equipment, submit a certificate or certified written

statement, signed by the engineer or technician, that the equipment is

installed in accordance with the manufacturer's recommendations.

PART 2

PRODUCTS

2.1

BOILERS

**************************************************************************

NOTE: Steam-atomizing burners should be specified

only if the boiler operating pressure exceeds 690

kPa (gage) 100 psig.

**************************************************************************

NOTE: Oil burners can have turndown ratio of 4,5,

or 6 to 1.

SECTION 15517N

Page 10