1.5
REGULATORY REQUIREMENTS
Conform to the safety and fire regulations of the Station Fire Department
when work is in progress. Obtain a "Hot Work" permit each day before
performing welding or burning.
1.6
CONCRETE CONSTRUCTION
Provide as specified in Section 03300N CAST-IN-PLACE CONCRETE, and as
modified herein.
1.7
EXCAVATING, BACKFILLING, AND COMPACTING
Provide as specified in Section 02300 EARTHWORK.
[1.8
CATHODIC PROTECTION
**************************************************************************
NOTE: The need for cathodic protection should be
evaluated on an individual project basis.
**************************************************************************
Provide cathodic protection in accordance with Section 13111N CATHODIC
PROTECTION BY IMPRESSED CURRENT.
]PART 2
PRODUCTS
2.1
SEISMIC RESTRAINT
**************************************************************************
NOTE: The SMACNA Seismic Restraint Manual
referenced in the paragraph below shall be applied
to locations subject to significant risk of seismic
induced loads. The degree to which this manual is
to be used for contract drawings and specifications
shall be determined by the designer of record in
coordination with the NAVFAC Engineering Field
Division's Mechanical Design Branch.
**************************************************************************
Provide fuel oil system including equipment, materials, installation,
workmanship, fabrication, assembly, erection, examination, inspection, and
testing shall be in accordance with ASME B31.3, [and NFPA 70,][NFPA 70 and
SMACNA Seismic Restraint Mnl,] as modified and supplemented by the contract
specifications and drawings.
2.2
SPECIAL REQUIREMENTS
2.2.1
Detail Drawing
Submit drawings showing aviation fuel distribution and dispensing system
including types, sizes, location, and installation details for:
a.
Pipe hangers and supports
b.
c.
Filter separator units
SECTION 15194N
Page 13
Previous Page
