The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN PETROLEUM INSTITUTE (API)
API Spec 6D
(2002) Specification for Pipeline Valves
ASTM INTERNATIONAL (ASTM)
ASTM A 53
(1999b) Pipe, Steel, Black and Hot-Dipped,
Zinc-Coated, Welded and Seamless
ASTM C 920
(2002) Elastomeric Joint Sealants
ASTM C 94
(1994) Ready-Mixed Concrete
MANUFACTURERS STANDARDIZATION SOCIETY OF THE VALVE AND FITTINGS
INDUSTRY (MSS)
MSS SP-72
Butt-Welding Ends for General Service
U.S. DEPARTMENT OF DEFENSE (DOD)
(Rev B; Notice 1) Coating Compound,
Bituminous, Solvent, Coal-Tar Base
MIL-P-29206
(Rev A; Am 2; Notice 1) Pipe and Pipe
Fittings, Glass Fiber Reinforced Plastic,
for Liquid Petroleum Lines
and Steel Body
MIL-V-18634
(Rev B; Notice 2) Valves:
Safety, Relief,
and Safety-Relief
U.S. GENERAL SERVICES ADMINISTRATION (GSA)
FS TT-S-001543
(Rev A) Sealing Compound: Silicone Rubber
Base (For Calking, Sealing, and Glazing in
Buildings and Other Structures)
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
SECTION 15191N
Page 4