equipment schedule or specifications, and location
of temperature and/or pressure sensors.
2. System Terminal Unit detail providing location
of all piping including valves, strainers, flanges,
fittings, connections, and supports (coordinate with
Section 15185N and Section 15183N).
3. Single line plan and any necessary sections
indicating location, sizes, and routing of all
associated piping.
4. Appropriate schedules for equipment, including
any reset schedules.
5. Information necessary when asbestos material is
involved (See second note in paragraph entitled
"Description").
6. Detail of connections to existing high or medium
temperature water piping, including air chambers and
vents as required.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI A13.1
(1996; R 2002) Scheme for Identification
of Piping Systems
ANSI B18.2.1
(1996; Errata 2003) Square and Hex Bolts
and Screws Inch Series
ANSI Z53.1
(1979) Safety Color Code for Marking
Physical Hazards
AMERICAN WELDING SOCIETY (AWS)
AWS B2.1
(2000) Welding Procedure and Performance
Qualification
AWS D1.1/D1.1M
(2004) Structural Welding Code - Steel
SECTION 15184N
Page 4