NOTE: The designer will specify the equipment and
features for the booth configuration and eliminate
the subparagraphs not needed.
**************************************************************************
a. CCTV Camera: The CCTV camera shall be designed and configured for
continuous operation and shall transmit video information to the
central station as specified in Section 16751A CLOSED CIRCUIT
TELEVISION SYSTEMS.
b. Weight Check Monitor: The entry booth shall incorporate a weight
check monitor which continuously monitors the weight of the booth plus
any occupant. The weight check monitor shall consist of synchronized,
matched, electronic load cells located at the base of the entry booth
and shall be connected to the local processor subsystem. The weight
check monitor shall be accurate to within plus or minus 2.3 kg 5 pounds.
The entry booth shall be designed to compensate for side loading to
prevent damage to the load cells by the passage of equipment through
the booth. Individual weights for each user shall be included in the
reference database files as part of the enrollment process. The design
of the entry booth shall provide a method to enter a custom, predefined
tolerance on valid weights of authorized persons. Each person's weight
profile shall be automatically updated based upon the last 3 uses of
entry control booths. The entry booth shall generate an entry control
alarm for any passage attempt for which the person's weight does not
agree with system reference database file data and confine the person.
The weight check monitor shall not increase the portal door threshold
height by more than 6 mm 1/4 inch.
c. Double Occupancy Floor Mat Sensor: Entry booths shall incorporate
a floor mat sensor to detect attempts at double occupancy. The double
occupancy floor mat sensor shall be connected to the local processor
subsystem. Activation of the double occupancy floor mat sensor shall
generate a system alarm and confine the enrollees. The double occupancy
floor mat sensor shall monitor the entire occupant area covered by a
rubber mat or indoor/outdoor carpet. The rubber mat or carpet shall be
at least 1.6 mm 1/16 inch thick and shall provide a continuous floor
covering with no seams.
d. Intercom: Each entry booth shall have 3 combination
speaker/microphones to provide 2 way communications at each of the
speaker/microphone locations. The speakers shall be at least 100 mm 4
inches in diameter. Two of the speaker/microphones shall be located,
one each, at the high and low security entry/exit doors, behind
louvered panels, to provide communications for people outside the
booth. The third speaker/microphone shall be located inside the booth
behind a perforated metal screen above the personal identity
verification device to provide communications for people inside the
booth. Each of the speaker/microphones shall be connected to the
operator console at the security center and to the voice prompt system
as indicated.
e. Voice Prompts: The entry booths shall include a voice prompt
system using human voice commands. Its purpose shall be to speed up
the entry control process and improve throughput rate. This audible
prompt system shall respond to the next sequential activity requirement
as each employee accesses the booth. All commands shall be stored in
electrically programmable read only memory chips located in the local
processor subsystem. The voice prompts shall only be directed to the
SECTION 13720A
Page 83
Previous Page
