ASTM D 2244
(2002e1) Calculation of Color Tolerances
and Color Differences from Instrumentally
Measured Color Coordinates
ASTM D 4214
(1998) Evaluating the Degree of Chalking
of Exterior Paint Films
ASTM D 4397
(2002) Polyethylene Sheeting for
Construction, Industrial, and Agricultural
Applications
ASTM E 84
(2004) Surface Burning Characteristics of
Building Materials
ASTM E 96
(2000e1) Water Vapor Transmission of
Materials
METAL BUILDING MANUFACTURERS ASSOCIATION (MBMA)
MBMA MBSM
(2002) Metal Building Systems Manual
SHEET METAL AND AIR CONDITIONING CONTRACTORS' NATIONAL ASSOCIATION
(SMACNA)
SMACNA Arch. Manual
(2003, 6th Ed) Architectural Sheet Metal
Manual
STEEL DOOR INSTITUTE (SDI)
SDI A250.8
(2003) Standard Steel Doors and Frames
U.S. ARMY CORPS OF ENGINEERS (USACE)
TI 809-04
(1998)
Seismic Design for Buildings
TI 809-07
(1998) Design of Cold-Formed Load Bearing
Steel Systems and Masonry Veneer/Steel
Stud Walls
UNDERWRITERS LABORATORIES (UL)
UL 580
(1994; Rev thru Feb 1998) Tests for Uplift
Resistance of Roof Assemblies
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
SECTION 13121
Page 6
Previous Page
