PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN BEARING MANUFACTURERS ASSOCIATION (ABMA)
ABMA SBRB
(Unknown) Ball and Roller Bearings and Ball
AMERICAN GAS ASSOCIATION (AGA)
AGA GMC
Gas Measurement Committee Report No. 3
AMERICAN GEAR MANUFACTURERS ASSOCIATION (AGMA)
AGMA 2001
(1995; Rev C) Fundamental Rating Factors
and Calculation Methods for Involute Spur
and Helical Gear Teeth
AGMA 2004
(1989; Rev B; R 1995) Gear Materials and
Heat Treatment Manual
AGMA 390.03A
(1980; Errata 1983; R 1988) Gear Handbook
Gear Classification, Materials and
Measuring Methods for Bevel, Hypoid, Fine
Pitch Wormgearing and Racks Only as
Unassembled Gears (Partially replaced by
AGMA 2000-A)
AGMA 6010
(1997; Rev F) Standard for Spur, Helical,
Herringbone, and Bevel Enclosed Drives
AGMA 6019
(1989; Rev E) Gearmotors Using Spur,
Helical, Herringbone, Straight Bevel, or
Spiral Bevel Gears
AGMA 6034
(1992; Rev B) Practice for Enclosed
Cylindrical Wormgear Speed Reducers and
Gearmotors
AGMA 908
(1989; Rev B, R 1999) Information Sheet:
Geometry Factors for Determining the
Pitting Resistance and Bending Strength of
Spur, Helical and Herringbone Gear Teeth
SECTION 11375N
Page 8
Previous Page
