2.6
ACCESSORIES [AND ACCESSORY EQUIPMENT]
**************************************************************************
NOTE: Specific project requirements may include one
or more of the following accessories:
Access platforms
Access ladders (with minimum 1050 mm 42 inch
extensions above hatch opening with locking device)
Handrailing
Waste oil transfer pump
Oily waste transfer pump
Sludge transfer pump
Sludge or waste oil storage tanks
Immersion heaters
Tank windows
System monitoring and control instrumentation (e.g.
oil content monitor, oil-water interface sensors,
control panel, pressure gages, high level alarms,
oil flooded alarms, tank level indicators)
Sight glasses
Inlet strainer (duplex)
Air vent valve
Pitot tube sampling valve assemblies
Check valves
Manually actuated valves
Motor actuated valves
Explosion proof doors
Separator backwash system
Select and specify as required. For those
accessories required in the project, specify
detailed requirements (including sizes, ratings,
capacities, performance characteristics) in
subparagraphs under paragraph entitled "ACCESSORIES
[AND ACCESSORY EQUIPMENT]."
**************************************************************************
**************************************************************************
NOTE: Review applicable Federal, State, and local
air pollution and ventilation requirements to
determine need for vapor containment.
**************************************************************************
Provide bolts, stiffeners, washers, nuts, screws, pins, gaskets, and
fittings as required for adjustable weirs, [separator covers] and parallel
plate packs [or vertical tube packs]. [Provide separator covers with a
vapor proof seal for vapor control with [_____] mm inch inside diameter gas
vents and suitable access manways to each separator compartment.]
2.7
FABRICATION
**************************************************************************
NOTE: Specific project requirements may include one
or more of the following accessories:
Access platforms
Access ladders (with minimum 1050 mm 42 inch
extensions above hatch opening with locking device)
SECTION 11311
Page 16
Previous Page
