label pockets formed as an integral part of the panel. Provide tags of two
types, one set for permanent holding of at least four keys. Provide
indexing to record information concerning locks and keys, alphabetically;
hook, numerically; and master key. Furnish permanent loan registry to
protect identity of key borrowers. Furnish receipt tabs to protect
identity of key borrowers and supply receipt tabs for temporary loan.
Provide one cabinet in the main control center, and one duplicate cabinet
in the Station Security Office and one duplicate cabinet in the Commanding
Officer Office.
2.10
DINING TABLE
Provide table designed for institutional use that permits seating in groups
of four. Table top shall be formed of not lighter than 10 gage stainless
steel, reinforced with steel plate. Corners shall be cut at a 45 degree
angle. Top, seat, and leg supports shall be heavy wall square steel
tubing. Seats shall be 300 mm 12 inch diameter made of high strength not
lighter than 16 gage stainless steel. Table with seats shall be one piece,
welded assembly, with welds neatly finished. Assembly framing shall be
painted, except for stainless steel, with one shop coat of primer. Table
top shall be not less than 900 mm 36 inches in the least dimension.
Provide in locations and quantity indicated.
PART 3
EXECUTION
3.1
INSTALLATION
3.1.1
Mirrors
Mount 1600 mm 64 inches up to center line, and anchor with 6 mm 1/4 inch
flat head spanner screw in lead masonry anchors.
3.1.2
Grab Bars
Install with 6 mm, 50 mm 1/4 inch, 2 inch long flat head screws in masonry
anchors. Provide a minimum of three fasteners per flange.
3.2
ADJUSTMENT
Adjust items and components of items specified in this section to ensure
proper operation.
-- End of Section --
SECTION 11195
Page 6
Previous Page
