other.
This unit shall be integrated into the hollow metal of the adjacent
unit.
2.4
GRAB BARS
Provide as specified in Section 10800 TOILET AND BATH ACCESSORIES, and in
lengths and configurations indicated.
2.5
PISTOL LOCKER UNITS
Outer shell and compartment doors shall be 5 mm 3/16 inch steel with
continuous hinges. Hinged tilt-out compartments shall be approximately 350
mm wide by 90 mm deep by 150 mm 14 inches wide by 3 1/2 inches deep by 6
inches high lined with moth-proofed felt and locked with an individually
keyed snaplock. Entire unit shall be coated with one shop coat of primer.
Unit shall be designed for recessed installation in masonry. Units shall
have nine compartments. Locate units as indicated.
2.6
SAFETY CLOTHES HOOKS
Provide 6 mm 1/4 inch steel hook and a 10 gage steel bracket safety clothes
hook designed to collapse under a heavy load. Provide an adjustable
friction device that permits variation of factory setting with use of a
simple spanner tool. Finish shall be cadmium plate. Provide 6 mm - 5 by
25 mm 1/4 inch - 20 by one inch flat head spanner machine screws to fit
widely spaced holes designed to resist abuse.
2.7
BUNKS
Cell bunks shall consist of a bed frame measuring 1980 mm long by 750 mm 78
inches long by 30 inches wide with front and back composed of an angle
measuring 50 by 50 by 6 mm 2 by 2 inches by 1/4 inch and ends of frame
formed by wall brackets made of 20 gage steel sheet flanged 50 mm 2 inches
at wall and lower edge. Back angle shall be kept 50 mm 2 inches from wall.
Bottom of bunk shall be made of not lighter than 16 gage steel sheet with
round or square holes with rounded corners, spaced as standard with the
manufacturer. Join the entire assembly by electrical welding; welds shall
be of deep penetration, continuous, and ground smooth. Prime bunks with
one shop coat of primer. Bunks shall be wall and floor mounted.
2.8
SEATS
Seats shall be designed for wall mounting to masonry walls with 6 mm 1/4
inch diameter by 500 mm 20 inch long spanner head screws in lead anchor.
Seat size shall be approximately 300 mm 12 incheswide by 450 mm 18 inches
deep; made of 5 mm 3/16 inch steel with 40 mm 1 1/2 inch flange for wall
mounting. Seat shall have one shop coat of primer paint. Provide in
locations and quantity indicated.
2.9
KEY CABINET
**************************************************************************
NOTE: Verify location of duplicate cabinet with the
Chief of Naval Personnel, PERS-84.
**************************************************************************
Provide for detention lock keys with a capacity of 1.75 times the number of
door locks and a complete dual-tag system. Cabinet shall have
concealed-type hinges and rounded sides and panels with individual hook and
SECTION 11195
Page 5
Previous Page
