Pass window
Grab bars
Pistol locker
Safety clothes hooks
Key cabinet
Bunks
Seats
Include details of frames, conditions of openings, details of
construction, location and installation requirements of hardware
and reinforcements, and details of joints and connections showing
sizes and locations of welds. Indicate fabrication, erection,
anchorage, and accessories.
1.3
DELIVERY, STORAGE, AND HANDLING
Deliver furniture and accessories in packaging to provide protection during
transit and job storage. Leave in unopened original containers, clearly
labeled for location of installation.
PART 2
PRODUCTS
2.1
MATERIAL
Steel plate, ASTM A 36/A 36M.
2.2
MIRRORS
a.
Mirror shall be 0.8 mm 0.031 inches thick sheet steel, highly
polished and bright chrome plated.
b.
Frame shall be 16 gage cold-finished steel with 8 mm 5/16 inch
inner and outer flanges.
c.
Mirror size shall be approximately 200 by 250 mm 8 by 10 inches
with overall size of approximately 250 by 290 mm 10 by 11 1/2
inches.
d.
Provide one framed mirror over lavatory in each prisoner housing
area.
2.3
PASS WINDOW
Window shall consist of a pass drawer below a speaker panel with a security
glazing panel above. The glazing panel shall be the same type as the
adjacent glazing. The pass drawer shall be 100 mm 4 inches deep, 400 mm 16
inches wide, and 300 mm 12 inches long and roll horizontally with an
interlocking hinged cover on both sides. The speaker panel shall be
constructed of perforated metal (T-304 stainless steel), 16 gage, 5 mm 3/16
inch perforated holes, rectangular in shape the full width of the panel,
with 14 gage baffles to prevent direct line of sight from one side to the
SECTION 11195
Page 4
Previous Page
