considered as being for information only for Army
projects and for Contractor Quality Control approval
for Navy projects.
**************************************************************************
Government approval is required for submittals with a "G" designation;
submittals not having a "G" designation are [for Contractor Quality Control
approval.][for information only. When used, a designation following the
"G" designation identifies the office that will review the submittal for
the Government.] The following shall be submitted in accordance with
Section 01330 SUBMITTAL PROCEDURES:
SD-03 Product Data
Glazing materials
Include glass manufacturer's printed literature for setting and
sealing materials and for cleaning of each type of glazing
material specified.
SD-04 Samples
Glazing materials
Submit samples, 250 mm 10 inches square, factory labeled, for
each type of glazing specified.
SD-08 Manufacturer's Instructions
Glass setting
1.3
DELIVERY, STORAGE, AND HANDLING
Deliver products to the site in their original unopened containers, plainly
labeled with manufacturers' names and brands. Store all glass and setting
materials in safe, dry locations and do not unpack until needed for
installation. Handle and install materials in a manner that protects them
from damage.
1.4
ENVIRONMENTAL CONDITIONS
Do not start glazing work until the outdoor temperature is above 4 degrees C
40 degrees F and rising unless approved provisions are made to warm the
glass and rabbet surfaces. Provide sufficient ventilation to prevent
condensation of moisture on glazing work during installation. Do not
perform glazing work during wet weather.
1.5
WARRANTY
**************************************************************************
NOTE: The warranty clause in this guide
specification has been approved by NAVFACENGCOMHQ in
accordance with the requirements of NAVFAC P-68. The
paragraph in this specification may be used without
any HQ approval or request for waiver.
**************************************************************************
Warranty glass units against development of material obstruction to vision
as a result of delamination, other than through glass breakage for at least
SECTION 11192
Page 5
Previous Page
