Style: Specify Style K unless Style H is requested
by the Using Agency.
Design: Design S - single lock. Design B - No
exterior hardware. Design S, the default value, is
more available. If B is a customer requirement,
check availability with manufacturers on the QPL.
APPROVAL OF AN EXCEPTION TO APPLICABLE SECURITY
REQUIREMENTS MUST BE OBTAINED BY THE USING ACTIVITY
THROUGH THEIR OPERATIONAL CHAIN OF COMMAND FOR
PROVISION AND INSTALLATION OF ANY AND ALL SECURITY
VAULT DOORS WITHOUT A GSA-APPROVED LABEL. The GSA
labeled vault door is a single-leaf door, and
provides a clear opening of 1015 mm (40 inches) wide
and 1980 mm (78 inches) high. A double-leaf vault
door is available with a clear opening of 2080 mm
(82 inches) wide and 1980 mm (78 inches) high. Both
single-leaf and double-leaf vault doors may be
obtained to satisfy special size requirements. The
double-leaf and special size units are built to
Class 5 standards, but are not tested and labeled by
GSA. When custom size doors are required, verify
availability with door manufacturers, and verify the
acceptability of unlabeled doors with the Using
Agency.
**************************************************************************
Design and construction of the door and frame assembly shall conform to FS
AA-D-600. The door shall be Class 5, Type [IR - right opening swing with
optical device] [IL - left opening swing with optical device ] [IIR - right
opening swing without optical device] [IIL - left opening swing without
optical device] [III R - double leaf, right opening swing active leaf] [III
L - double leaf, left opening swing active leaf], Style [H - hand change
combination lock] [K - key change combination lock], Design [S - single
lock] [B - no exterior hardware]. [The optical device shall permit
observation from the [inside to the outside] [outside to the inside] of the
vault.]
2.2
DAY GATE
**************************************************************************
NOTE: The day gate is not covered by FS AA-D-600.
Specify the day gate only when specifically
requested by the Using Agency.
**************************************************************************
The day gate shall be the manufacturer's [standard] [custom] product
designed for use with the vault door furnished, and shall provide access
control [and visual security] [and [material] [equipment] [weapons] issue].
The gate shall be hinged on the same side as the vault door, shall swing
into the vault, and shall have a locking device operable from outside by
key and from inside by knob or handle. [Gate shall include an issue port
hatch [and [2.5] [_____] mm [12] [_____] gage thick steel shelf]. The issue
port shall be a framed 200 by 300 mm 8 by 12 inch opening with a minimum
[0.8] [_____] mm [22] [_____] gage thick steel protective door (hatch
cover) which is hinged and lockable from the interior side. The issue port
frame shall be welded to the day gate. [The shelf shall be [300] [_____]
mm [12] [_____] inches deep by width to match the port hatch.]] Provide
SECTION 11020
Page 5
Previous Page
