SSPC VIS 1
(2002) Guide and Reference Photographs for
Steel Surfaces Prepared by Dry Abrasive
Blast Cleaning
U.S. DEPARTMENT OF DEFENSE (DOD)
(Rev B; Am 2) Abrasive Blasting Media Ship
Hull Blast Cleaning
MIL-DTL-24441
(Rev C; Supp 1) Paint, Epoxy-Polyamide
MIL-DTL-24441/29
(Rev A) Paint, Epoxy-Polyamide, Green
Primer, Formula 150, Type IV
MIL-DTL-24441/31
(Rev A) Paint, Epoxy-Polyamide, White,
Formula 152, Type IV
U.S. GENERAL SERVICES ADMINISTRATION (GSA)
FED-STD-595
(Rev B; Am 1) Colors, Volume
1
U.S. NATIONAL ARCHIVES AND RECORDS ADMINISTRATION (NARA)
29 CFR 1910-SUBPART Z
Toxic and Hazardous Substances
29 CFR 1910.1000
Air Contaminants
29 CFR 1910.134
Respiratory Protection
29 CFR 1926.59
Hazard Communication
1.2
DEFINITIONS
Definitions are provided throughout this Section, generally in the Article
where used, and denoted by capital letters. The following definitions are
used throughout this Section:
a. CEILING - interior tank surfaces that extend from the
horizontal plane at the designated maximum fuel line upward,
including the upper portion of the tank shell (walls), columns,
structural steel, the underside of the roof plates and other steel
components in this area.
b. SHELL - interior tank surfaces that extend along the vertical
tank walls between the horizontal planes approximately 1 meter 40
inches above the shell to bottom joint upward to the horizontal
plane at the designated fuel line, including columns, wall plates,
and other steel components in this area.
c. FLOOR - interior tank surfaces below the horizontal plane
approximately 1 meter 40 inches above the shell to bottom joint,
including columns, wall plates, piping, pipe supports, bottom
plates, and other steel components in this area.
1.3
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
SECTION 09973
Page 8
Previous Page
