PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
APA - THE ENGINEERED WOOD ASSOCIATION (APA)
APA E30
(2003) Engineered Wood Construction Guide
ASTM INTERNATIONAL (ASTM)
ASTM D 226
(1997a) Asphalt-Saturated Organic Felt
Used in Roofing and Waterproofing
ASTM E 1333
(1996; R 2002) Determining Formaldehyde
Concentrations in Air and Emission Rates
from Wood Products Using a Large Chamber
ASTM E 648
(2003) Critical Radiant Flux of
Floor-Covering Systems Using a Radiant
Heat Energy Source
HARDWOOD PLYWOOD AND VENEER ASSOCIATION (HPVA)
HPVA EF
(2002) American National Standard for
Engineered Wood Flooring
NOFMA: THE WOOD FLOORING MANUFACTURERS ASSOCIATION (NOFMA)
NOFMA Grading Rules
(1999) Official Flooring Grading Rules
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
SECTION 09645
Page 4
Previous Page
