PART 2
PRODUCTS
2.1
MATERIALS
2.1.1
Aluminum
AAMA 1002.10.
2.1.2
Storm Windows
**************************************************************************
NOTE: See referenced publications for requirements
not included in this section. The designations
listed are:
FWE - Fixed-Removable Insulating Storm Windows for
External Application
HWE - Horizontally Operating Insulating Storm
Windows for External Application
VWE - Vertically Operating Insulating Storm
Windows for External Application
SGE - Sliding Glass Insulating Storm Door for
External Application
**************************************************************************
AAMA 1002.10, Specification [FWE,] [HWE,] [VWE,] [FWI,] [HWI,] [VWI,]
except as otherwise specified herein. Windows shall have a Performance
Class of [20] [30] [40] [_____]. Extrusions shall have a nominal wall
thickness of not less than 1.14 mm 0.045 inch.
2.1.3
Sealant
ASTM C 920, Type S or M, Grade NS, Class 12.5, use NT, Color [_____].
Sealant shall have been tested for use with the materials on which it will
be used in this project.
2.2
FABRICATION
AAMA 1002.10.
2.2.1
Connections
Rigidly connect frames at corners so as to prevent racking during normal
handling and installation.
2.2.2
Locks or Latches
On vertically operating inserts, locks shall engage round holes or deep
notches in the main frame. On horizontally operating inserts, latches
shall automatically engage a groove or ridge on the main frame or sash.
2.2.3
Access for Cleaning
Inserts, both operating and non-operating, shall be removable for cleaning.
[Where fixed sashes are indicated, the inserts shall be normally fixed but
removable for cleaning.] Where prime windows have only one operating sash,
SECTION 08582
Page 5
Previous Page
