**************************************************************************
Provide double-head anchors for windows [indicated] [specified]. Anchors
shall be stainless steel of size and design conforming to ASME A39.1.
Provide two anchors for each single window [and each adjacent glass window
unit]. Fasten anchors 1120 mm 44 inches above the window sill in
accordance with ASME A39.1.
2.5.11
**************************************************************************
NOTE: Specify anodic and organic coatings as
Contractor's option when these finishes are
determined to be economically competitive in the
project area, unless the project requires use of one
or the other to match an existing condition.
**************************************************************************
Exposed aluminum surfaces shall be factory finished with an [anodic
coating] [or] [organic coating]. [Color shall be [_____] [as indicated].]
Windows [for each building] shall have the same finish.
2.5.11.1
Anodic Coating
**************************************************************************
NOTE: Specify Architectural Class I for highly
corrosive industrial atmospheres where dust, gases,
salts, and other destructive elements that attack
metal exist. Specify Architectural Class II for all
atmospheric conditions not requiring Class I.
**************************************************************************
Clean exposed aluminum surfaces and provide an anodized finish conforming
to AA DAF-45. Finish shall be [_____].
2.5.11.2
Organic Coating
**************************************************************************
NOTE: When anodic and organic coatings are
determined to be economically competitive in the
project area, specify baked enamel finish (AAMA
2603) as an option to Architectural Class II, anodic
coating, or high-performance finish (AAMA 2604) as
an option to Architectural Class I, anodic coating.
**************************************************************************
Clean and prime exposed aluminum surfaces. Provide a [baked enamel finish
in accordance with AAMA 2603 with total dry film thickness not less than
0.02 mm 0.8 mil] [high-performance finish in accordance with AAMA 2604 with
total dry film thickness of not less than 0.03 mm 1.2 mils].
2.6
SOURCE QUALITY CONTROL
2.6.1
Window Assembly Structural Test
2.6.1.1
Test Sample Number
At least two sample window assemblies for each type of window provided
shall be tested, under an increasing uniform static load.
Number of
SECTION 08581
Page 11
Previous Page
