AAMA 2604
(2002) Voluntary Specification,
Performance Requirements and Test
Procedures for High Performance Organic
Coatings on Aluminum Extrusions and Panels
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI Z97.1
(1984; R 1994) Safety Glazing Materials
Used in Buildings
ASME INTERNATIONAL (ASME)
ASME A39.1
(1995; A39.1a; A39.1b) Safety Requirements
for Window Cleaning
ASTM INTERNATIONAL (ASTM)
ASTM C 1048
(2004) Heat-Treated Flat Glass - Kind HS,
Kind FT Coated and Uncoated Glass
ASTM C 509
(2000) Elastomeric Cellular Preformed
Gasket and Sealing Material
ASTM C 920
(2002) Elastomeric Joint Sealants
GLASS ASSOCIATION OF NORTH AMERICA (GANA)
GANA Glazing Manual
(2004) Glazing Manual
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
SECTION 08581
Page 5
Previous Page
