to AAMA 2603, with total dry film thickness not less than 0.02 mm 0.8 mil.
The finish color shall be [white] [as indicated] [_____].
2.3.2
Steel
Parts formed from hot-dipped galvanized steel shall be bonderized before
and after assembly. After fabrication and assembly, materials shall be
finished with a baked enamel finish. Color shall be [_____] [as indicated]
[as selected from manufacturer's chart].
PART 3
EXECUTION
3.1
PREPARATION
**************************************************************************
NOTE: Insert additional subparagraphs on repairing,
reputtying, sanding, and painting to suit the
project.
**************************************************************************
Thoroughly clean and repair surfaces to which storm door frames will be
applied.
3.2
INSTALLATION
Install square, in a true plane, level, plumb, in alignment with adjacent
construction, and in accordance with manufacturer's printed directions.
3.2.1
Sealants
Make the entire perimeter of the main frame weathertight.
Provide gaskets
to separate new metal from existing metal.
3.2.2
Fastening
Attach units with panhead screws of adequate dimensions for the particular
installation.
3.3
CLEANING
After installation, clean exposed surfaces to remove foreign matter and
surface blemishes. Remove damaged units and units which cannot be cleaned
satisfactorily and provide new units.
3.4
SCHEDULE
Some metric measurements in this section are based on mathematical
conversion of English unit measurements, and not on metric measurements
commonly agreed to by the manufacturers or other parties. The English and
metric units for the measurements shown are as follows:
Products
English Units
Metric Units
Steel
24
gage
0.6
mm
22
gage
0.8
mm
18
gage
1.2
mm
16
gage
1.5
mm
Aluminum tubular sections
1 x 2 1/4 inches
25 x 57 mm
SECTION 08181
Page 9