extent referenced. The publications are referred to within the text by the
basic designation only.
ALUMINUM ASSOCIATION (AA)
AA DAF-45
(2003) Designation System for Aluminum
AMERICAN ARCHITECTURAL MANUFACTURERS ASSOCIATION (AAMA)
AAMA 1102.7
(1989) Voluntary Specifications for
Aluminum Storm Doors
AAMA 2603
(2002) Voluntary Specification,
Performance Requirements and Test
Procedures for Pigmented Organic Coatings
on Aluminum Extrusions and Panels
AAMA 611
(1998) Voluntary Specification for
Anodized Architectural Aluminum; includes
604.2, 606.1, 607.1 and 608.1 (which are
no longer available as separate documents)
ASTM INTERNATIONAL (ASTM)
ASTM B 209
(2004) Aluminum and Aluminum-Alloy Sheet
and Plate
ASTM B 209M
(2004) Aluminum and Aluminum-Alloy Sheet
and Plate (Metric)
ASTM B 221
(2004a) Aluminum and Aluminum-Alloy
Extruded Bars, Rods, Wire, Profiles, and
Tubes
ASTM B 221M
(2004) Aluminum and Aluminum-Alloy
Extruded Bars, Rods, Wire, Profiles, and
Tubes (Metric)
ASTM C 1048
(2004) Heat-Treated Flat Glass - Kind HS,
Kind FT Coated and Uncoated Glass
ASTM C 920
(2002) Elastomeric Joint Sealants
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
SECTION 08181
Page 4
Previous Page
