inclined track, single-sliding, center-parting pair.
5. Type of power operators if used, service
characteristics and connection points.
6. Location and type of controls if power operators
are used.
7. Solid grouting of jambs in hollow core masonry.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
ASTM INTERNATIONAL (ASTM)
ASTM A 123/A 123M
(2002) Zinc (Hot-Dip Galvanized) Coatings
on Iron and Steel Products
ASTM A 653/A 653M
(2004a) Steel Sheet, Zinc-Coated
(Galvanized) or Zinc-Iron Alloy-Coated
(Galvannealed) by the Hot-Dip Process
ASTM C 1036
(2001) Flat Glass
FM GLOBAL (FM)
FM P7825
(2003) Approval Guide
NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA)
NEMA ICS 1
(2000) Industrial Control and Systems:
General Requirements
NEMA ICS 2
(2000; R
2004) Industrial Controls and
Systems:
Controllers, Contactors, and
Overload
Relays Rated Not More than 2000
Volts AC
or 750 Volts DC
NEMA ICS 6
(1993; R 2001) Industrial Control and
Systems: Enclosures
NEMA MG 1
(2003; R 2004) Motors and Generators
SECTION 08162
Page 4
Previous Page
