PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN WOOD-PRESERVERS' ASSOCIATION (AWPA)
AWPA C1
(2000) All Timber Products - Preservative
Treatment by Pressure Processes
ASTM INTERNATIONAL (ASTM)
ASTM C 1177/C 1177M
(2004e1) Glass Mat Gypsum Substrate for
Use as Sheathing
ASTM C 270
(2004a) Mortar for Unit Masonry
ASTM C 67
(2003a) Sampling and Testing Brick and
Structural Clay Tile
ASTM D 2178
(2004) Asphalt Glass Felt Used in Roofing
and Waterproofing
ASTM D 412
(1998a; R 2002e1) Vulcanized Rubber and
Thermoplastic Elastomers - Tension
ASTM D 4586
(2000) Asphalt Roof Cement, Asbestos-Free
ASTM E 108
(2004) Fire Tests of Roof Coverings
ASTM E 84
(2004) Surface Burning Characteristics of
Building Materials
NATIONAL ROOFING CONTRACTORS ASSOCIATION (NRCA)
NRCA SRM
(2004, 5th Ed) Steep-Slope Roofing Manual
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
SECTION 07320N
Page 4
Previous Page
