ASTM D 429
(2003) Rubber Property-Adhesion to Rigid
Substrates
ASTM D 471
(1998e1) Rubber Property - Effect of
Liquids
ASTM D 5385
(1993; R 2000e1) Hydrostatic Pressure
Resistance of Waterproofing Membranes
ASTM D 570
(1998) Water Absorption of Plastics
ASTM D 573
(2004) Rubber - Deterioration in an Air
Oven
ASTM D 624
(2000e1) Tear Strength of Conventional
Vulcanized Rubber and Thermoplastic
Elastomers
ASTM D 638
(2003) Tensile Properties of Plastics
ASTM D 746
(2004) Brittleness Temperature of Plastics
and Elastomers by Impact
ASTM D 751
(2000) Coated Fabrics
ASTM D 903
(1998; R 2004) Peel or Stripping Strength
of Adhesive Bonds
ASTM E 154
(1999) Water Vapor Retarders Used in
Contact with Earth Under Concrete Slabs,
on Walls, or as Ground Cover
ASTM E 96
(2000e1) Water Vapor Transmission of
Materials
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
SECTION 07131
Page 5
Previous Page
