SD-02 Shop Drawings
Framing Components; G, [_____]
a. Cross sections, plans, and/or elevations showing component
types and locations for each framing application; including shop
coatings and material thicknesses for each framing component.
b. Connection details showing fastener type, quantity,
location, and other information to assure proper installation.
c. Drawings depicting panel configuration, dimensions,
components, locations, and construction sequence if the Contractor
elects to install prefabricated/prefinished frames.
SD-03 Product Data
Steel studs,joists, tracks, bracing, bridging and accessories
[
SD-05 Design Data
**************************************************************************
NOTE: Require calculations for items considered
critical by the designer. Delete paragraph if
calculations are not necessary.
**************************************************************************
Metal framing calculations; G, [_____]]
SD-07 Certificates
Load-bearing cold-formed metal framing
Mill certificates or test reports from independent testing
agency, qualified in accordance with ASTM E 329, showing that the
steel sheet used in the manufacture of each cold-formed component
complies with the minimum yield strengths and uncoated steel
thickness specified. Test reports shall be based on the results
of three coupon tests in accordance with ASTM A 370.
Welds
Certified copies of welder qualifications test records showing
qualification in accordance with AWS D1.3.
1.3
DELIVERY, STORAGE, AND HANDLING
Deliver materials to job site and store in adequately ventilated, dry
locations. Storage area shall permit easy access for inspection and
handling. If necessary to store materials outside, stack off the ground,
support on a level platform, and protect from the weather as approved.
Handle materials to prevent damage. Finish of the framing members shall be
maintained at all times, using an approved high zinc dust content,
galvanizing repair paint whenever necessary to prevent the formation of
rust. Replace damaged items with new, as directed by the Contracting
Officer.
SECTION 05400
Page 6
Previous Page
