**************************************************************************
USACE / NAVFAC / AFCESA
UFGS-05400 (October 2003)
------------------------------
Preparing Activity: NAVFAC
Superseding
UFGS-05400N (September 1999)
UFGS-05400A (January 2002)
UNIFIED FACILITIES GUIDE SPECIFICATIONS
References are in agreement with UMRL dated 23 June 2005
**************************************************************************
SECTION 05400
COLD-FORMED METAL FRAMING
10/03
**************************************************************************
NOTE: This guide specification covers the
requirements for framing components and erection of
load-bearing light gage steel.
Comments and suggestions on this guide specification
are welcome and should be directed to the technical
proponent of the specification. A listing of
technical proponents, including their organization
designation and telephone number, is on the Internet.
Recommended changes to a UFGS should be submitted as
a Criteria Change Request (CCR).
Use of electronic communication is encouraged.
Brackets are used in the text to indicate designer
choices or locations where text must be supplied by
the designer.
**************************************************************************
**************************************************************************
NOTE: The following information shall be shown on
the project drawings:
1. The extent and location of all framing
indicating gage, size, section modulus, and other
structural properties required.
2.
Connections and other installation details.
3. Indicate concentrated loads, e.g., pipe
supports, that may overstress a flange or connection.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
SECTION 05400
Page 3
Previous Page
