Class B coating
Bolts, nuts, and washers
Supply the certified manufacturer's mill reports which clearly
show the applicable ASTM mechanical and chemical requirements
together with the actual test results for the supplied fasteners.
SD-07 Certificates
Steel
Bolts, nuts, and washers
Shop primer
Welding electrodes and rods
Nonshrink grout
[
Galvanizing]
[
Pins and rollers]
[
AISC Quality Certification]
Overhead, top running crane rail beam
Welding procedures and qualifications
[1.5
AISC QUALITY CERTIFICATION
**************************************************************************
NOTE: AISC has a certification program in effect
that confirms that a certified structural steel
fabricating plant has the personnel, organization,
experience, procedures, knowledge, equipment,
capability, and commitment to produce fabricated
steel of the required quality for a given category
of structural steel framing. Consider deleting this
paragraph if there is a minimal amount of steel on
the job. Use Category "Sbd" for Conventional Steel
Structures, (replaces Category I); use Category
"Sbr" for Simple Steel Bridge Structures, (replaces
Category I); use Category "Cbd" for Complex Steel
Building Structures, (replaces Category II); use
Category "Cbr" for Major Steel Bridges, (replaces
Category III); and use Category "MB" for Metal
Building Systems.
**************************************************************************
Work shall be fabricated in an AISC certified Category [Sbd] [_____]
fabrication plant.
][1.6
SEISMIC PROVISIONS
**************************************************************************
NOTE: When using AISC 325 (load and resistance
factor) for design, and the project is in Seismic
SECTION 05120
Page 11
Previous Page
