7. Fire Rating. Show special connections or
details.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI A108.1
(1999) Installation of Ceramic Tile;
including A108.1A-C, 108.4-.13, 118.1-.10,
A136.1
ASTM INTERNATIONAL (ASTM)
ASTM A 153/A 153M
(2004) Zinc Coating (Hot-Dip) on Iron and
Steel Hardware
ASTM A 568/A 568M
(2004) Steel, Sheet, Carbon, and
High-Strength, Low-Alloy, Hot-Rolled and
Cold-Rolled, General Requirements for
ASTM A 82
(2002) Steel Wire, Plain, for Concrete
Reinforcement
ASTM C 126
(1999) Ceramic Glazed Structural Clay
Facing Tile, Facing Brick, and Solid
Masonry Units
ASTM C 270
(2004a) Mortar for Unit Masonry
ASTM C 476
(2002) Grout for Masonry
ASTM C 744
(1999) Prefaced Concrete and Calcium
Silicate Masonry Units
ASTM C 90
(2003) Loadbearing Concrete Masonry Units
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
SECTION 04215
Page 4
Previous Page
