point-of-contact for similar projects which demonstrates the
required experience and/or training. Submit resumes, pertinent
information, past experience, training, and education of all
operators of specialized demolition equipment.
SD-03 Product Data
Rapid-Hardening Repair Material
Polymer Modifier
Latex Bonding Compound
Polyurethane Injection Adhesive
Polyester Resin Grout
Epoxy Resin Materials
Bond Breaker
Fiber Reinforcement
Neoprene Bearing Pads for Precast Units; [ ], [
]
Mechanical Anchors
High Molecular Weight Methacrylate (HMWM) Sealer
Submit manufacturer's literature from suppliers that
demonstrates compliance with applicable specifications for the
above materials. For proportioned materials, submit three copies
of the proposed mix design prior to placement. The mix design
shall indicate the weight of each ingredient of the mixture. No
concrete shall be placed prior to approval of the proposed mix
design. No deviation from the approved job-mix formula will be
permitted without prior approval.
Testing Technicians
Submit statements that the concrete testing technicians meet the
specified requirements.
SD-04 Samples
Field Molded Sealants and Primer
Provide four liters one gallon of field-molded sealant and 1 L
one quart of primer (when primer is recommended by the sealant
manufacturer) for testing.
[Epoxy-Coated SteelBars
Sample of coating material and 700 g1.5 pounds of patching
material shall be submitted with the delivery of the bars.]
SD-05 Design Data
Repair material mixture proportioning
Submit mixture proportioning and test results.
SD-06 Test Reports
**************************************************************************
NOTE: Test reports should be required unless the
repairs are considered minor and non-critical, in
which case manufacturer's certificates could be
accepted.
SECTION 03931
Page 26
Previous Page
