shall be composed of rotationally molded, low density elastomer, and
internally reinforced with a steel ring. The tire shall have no openings
for insects or water. The multiple-axis swing shall not be confused with
the multiple occupancy swing as they are not the same.
2.2.7
Single-Axis (To-Fro) Swing
2.2.7.1
General Requirements
The swing seat shall be molded of high quality rubber or polyurethane with
an encapsulated steel reinforcement. The swing seat shall be designed to
accommodate one user
2.2.7.2
Full Bucket Swing Seat
A full bucket swing seat is designed to accommodate children up to a
maximum 4 years of age; the seat is used by a child with adult assistance.
The swing seat shall be constructed of rubber with a tempered steel insert
molded inside, shall be double-sided, shall be enclosed by rubber both
front and back, and shall include a 360 degree waist enclosure and leg
enclosures. Leg enclosures shall be sized to avoid head or neck
entrapment. Finish shall be smooth and edges shall be rounded. These
swing seats shall not be mixed with other swing seats within a bay.
2.2.8
Spring Rocking Equipment
Spring mechanisms shall conform to the requirements for pinch, crush, and
shear points for a maximum 54 kg 120 lb weight limit in accordance with
ASTM F 1487. Seats shall be designed to accommodate only the intended
number of users.
2.2.9
Roofs
Roofs shall contain no designated play surface.
2.2.10
Sliding Poles
Sliding poles shall be a maximum 48 mm 1.9 inch diameter and a continuous
surface with no protruding welds or joints along the sliding area.
2.2.11
Plastic Slide
**************************************************************************
NOTE: Plastic is the preferred slide material, and
shall be installed to face in any direction but
north.
**************************************************************************
The slide shall be molded of UV stabilized polyethylene or nylon with
minimum of 5 mm 3/16 inch wall thickness. The edge shall be a minimum 5 mm
3/16 inch radius, ASTM D 1248, Type II, Class A, Grade G4.
2.2.12
Play House or Enclosures
The play house shall be provided with a shelf at the window. The play
house and enclosures will be designed to provide other than direct outside
visibility from a minimum 1.5 m 5 feet to all inside corners.
SECTION 02882
Page 20
Previous Page
