**************************************************************************
USACE / NAVFAC / AFCESA
UFGS-02785 (July 2003)
----------------------------
Preparing Activity: USACE
Superseding
UFGS-02785A (July 1997)
UFGS-02785N (September 1999)
UFGS-02786N (July 1997)
UFGS-02789N (September 1999)
UNIFIED FACILITIES GUIDE SPECIFICATIONS
References are in agreement with UMRL dated 23 June 2005
**************************************************************************
SECTION 02785
BITUMINOUS SEAL AND FOG COATS
07/03
**************************************************************************
NOTE: This guide specification covers the
requirements for bituminous surface coatings for low
volume roads, parking areas, and other general
applications.
Comments and suggestions on this guide specification
are welcome and should be directed to the technical
proponent of the specification. A listing of
technical proponents, including their organization
designation and telephone number, is on the Internet.
Recommended changes to a UFGS should be submitted as
a Criteria Change Request (CCR).
Use of electronic communication is encouraged.
Brackets are used in the text to indicate designer
choices or locations where text must be supplied by
the designer.
UFC 3-250-03 should be used for guidance in
preparing these specifications.
**************************************************************************
PART 1
GENERAL
**************************************************************************
NOTE: Bituminous seal coat should not be used on
primary roads or airfield areas. Fog seals lower
the frictional resistance of paved surfaces and will
not be used on runways, high speed taxiway turnoffs,
or moderate to high speed roads unless approval is
obtained from NAVFACENGCOMHQ, AFCESA or the TSMCX.
This section must be edited to remove all references
to Fog Seal when it is not required in the project.
**************************************************************************
SECTION 02785
Page 3
Previous Page
