gallon, and shall have the approximate chemical form as shown below:
Constituent
Limit (Percent by Mass)
LiNo (Lithium Nitrate)
30 +/- 0.5
SO
(Sulfate Ion)
0.1 (max)
Cl
(Chloride Ion)
0.2 (max)
Na
(Sodium Ion)
0.1 (max)
K
(Potassium Ion)
0.1 (max)
The Lithium Nitrate manufacturer shall provide a trained representative to
supervise the lithium nitrate admixture dispensing and mixing operations.
2.4
MEMBRANE FORMING CURING COMPOUND
**************************************************************************
NOTE: ASTM C 309 may be used for roads and streets
and Navy airfield pavements. Use CRD-C 300 for Army
or Air Force airfield pavement projects.
**************************************************************************
Membrane forming curing compound shall [be a white pigmented compound
conforming to COE CRD-C 300.] [conform to ASTM C 309, white-pigmented Type
2, Class B].
2.5
WATER
Water for mixing and curing shall be fresh, clean, potable, and free of
injurious amounts of oil, acid, salt, or alkali, except that non-potable
water may be used if it meets the requirements of ASTM C 94/C 94M.
2.6
JOINT MATERIALS
**************************************************************************
NOTE: Edit as appropriate for project requirements.
Coordinate with UFGS 02760A and 02762A for Army and
Air Force projects. Coordinate with UFGS 02762N for
Navy projects.
**************************************************************************
2.6.1
Expansion Joint Material
Expansion joint filler shall be a preformed material conforming to [ASTM D
1751 or] [ASTM D 1752 Type [II] [III].] Expansion joint filler shall be 20
mm 3/4 inch thick, and shall be furnished in a single full depth piece.
2.6.2
Slip Joint Material
Slip joint material shall be 6 mm 1/4 inch thick expansion joint filler
conforming to para: Expansion Joint Material.
2.7
REINFORCING
**************************************************************************
NOTE: Edit these paragraphs to conform to project
requirements. Delete those not needed. Add
epoxy-coated bars (ASTM A 775) or low-alloy bars
(ASTM A 706) when required by design.
**************************************************************************
SECTION 02753
Page 44
Previous Page
