MANUFACTURED ITEMS

2.1.6

Polyethylene Tubing

2.1.6.1

Smooth Polyethylene Tubing

[ASTM D 3350] [ASTM D 1248, Type III].

2.1.6.2

Corrugated Polyethylene Tubing

AASHTO M 252, with average minimum wall thickness of 1.5 mm 0.06 inch.

2.1.7

Smooth Polypropylene Tubing

ASTM D 4101, designation PP 210 B5542-11.

2.1.8

Polyvinyl Chloride (PVC) Pipe

ASTM D 1785, Schedule 40.

2.1.9

Polyvinyl Chloride (PVC) Tubing

2.1.9.1

Smooth Polyvinyl Chloride (PVC) Tubing

ASTM D 1784.

2.1.9.2

Corrugated Polyvinyl Chloride (PVC) Tubing

Manufactured from rigid PVC compounds conforming to ASTM D 1784, Class

13464-8 with average minimum wall thickness of 1.0 mm 0.04 inch.

2.1.10

Heat Shrinkable Sleeve

Radiation crosslinked polyolefin tube internally coated with and adhesive

sealant.

2.1.11

Corrosion Inhibiting Compound

The corrosion inhibiting compound shall conform to the requirements of

Section 3.2.5 of PTI 8.

2.2

MANUFACTURED ITEMS

2.2.1

Anchor Head

Anchor head shall consist of [steel bearing plate with wedge plate and

wedges for strand anchors] [or] [steel bearing plate with nut for bar

anchors], trumpet and corrosion protection. Anchorage devices shall be

capable of developing 95 percent of the guaranteed ultimate strength of

prestressing steel. The anchorage devices shall conform to the static

strength requirements of Section 3.1.6 (1) and Section 3.1.8 (1) and (2) of

PTI A. [Wedges shall be designed to not cause premature failure of the

prestressing steel due to notching or pinching. Special wedges shall be

provided as required for epoxy coated strand. Removal of epoxy coating to

permit use of standard wedges will not be permitted.] [Threaded anchorage

items for epoxy coated bars shall be designed to fit over the epoxy coating

and maintain the capacity of the prestressing steel.] The trumpet used to

provide a transition from the anchorage to the unbonded length corrosion

protection shall be fabricated from steel pipe or steel tube. The minimum

wall thickness shall be 3.0 mm for diameters up to 100 mm and 5.0 mm for

larger diameters 0.125 inch for diameters up to 4 inches and 0.20 inch for

SECTION 02490

Page 22