projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
Codes for Army projects using the Resident
Management System (RMS) are: "AE" for
Architect-Engineer; "DO" for District Office
(Engineering Division or other organization in the
District Office); "AO" for Area Office; "RO" for
Resident Office; and "PO" for Project Office. Codes
following the "G" typically are not used for Navy
projects.
Submittal items not designated with a "G" are
considered as being for information only for Army
projects and for Contractor Quality Control approval
for Navy projects.
**************************************************************************
Government approval is required for submittals with a "G" designation;
submittals not having a "G" designation are [for Contractor Quality Control
approval.][for information only. When used, a designation following the
"G" designation identifies the office that will review the submittal for
the Government.] The following shall be submitted in accordance with
Section 01330 SUBMITTAL PROCEDURES:
**************************************************************************
NOTE: Include the bracketed option on "CI44" and
074 review" for LANTNAVFACENGCOM and
SOUTHNAVFACENGCOM projects respectively. For other
projects, submittal review shall be performed by the
designer of record; If submittal review by
LANTNAVFACENGCOM or SOUTHNAVFACENGCOM is
specifically desired, the responsible Government
agency must coordinate with the respective Code CI44
or 074 during the design process. Add appropriate
information in Section titled "Submittal Procedures"
to coordinate with the special requirements.
**************************************************************************
[[Code CI44, Atlantic] [Code 074, Southern] Division, Naval Facilities
Engineering Command will review and approve transformer submittals.] As an
exception to this paragraph, transformers manufactured by ABB in Athens,
GA; by Cooper Power Systems in Waukesha, WI or Nacogdoches, TX; or by
Howard Industries in Laurel, MS need not meet the submittal requirements of
this contract. Instead, the following shall be submitted.
a.
A certification, from the manufacturer, that the technical
requirements of this specification shall be met.
b.
Routine and other tests (paragraph entitled "Routine and Other
Tests, shall be conducted by the manufacturer and [may] [will] be
witnessed by the Government (paragraph entitled "Source Quality
Control"). Provide certified copies of the tests.
c.
Provide field test reports (paragraph entitled "Field Quality
Control").
SD-03 Product Data
SECTION 16301N
Page 11
Previous Page
