c.
Dampers
d.
Instruments and control devices
e.
Control panels
f.
g.
Atomizers
h.
Fabric filter baghouse
i.
Ductwork
j.
Expansion joints
k.
Fans
l.
Pumps
m.
Access systems
1.4.1.3
Piping Drawings
Submit general arrangement and outline, piping fabrication, erection,
piping connection, valves, pipe hangers, insulation, and instrumentation.
Contractor shall submit complete drawings for piping furnished in plan and
elevation. Submit dimensions required for fabrication and assembly of
piping components and location of field joints and identify components with
piece mark numbers, location of hangers and supports, and the location of
instrument, vent, and drain connections. Submit drawings showing
approximate field routing for instrument control tubing bundles. Include
details of engineered hanger assemblies showing plan location, elevations
of piping and support steel in the design, cold and hot positions, design
loads, and a complete bill of materials.
1.4.1.4
Wiring Diagrams
Include a wiring diagram with each wire or wire bundle shown by a line, or
a point-to-point type wiring diagram with individual wire designations
listed at the location of each termination and identify device and
equipment terminals, and internal and external connection terminal blocks.
1.4.1.5
Schematic Control Diagrams
Submit elementary diagrams of control and alarm functions, both internal
and external to the equipment, wire colors, ANSI symbols circuit
designations, and identify external connection terminals and terminal
blocks. Submit process and piping instrumentation diagrams, analog control
system functional diagrams and associated logic, logic diagrams of digital
systems, flow charts or word logic of software systems, description of
operation of each control system, electrical interconnection drawings
showing external terminal blocks for each input, output, and power cable
connection and destination of other end of cable, analog and digital signal
input and output lists, and nameplate lists.
SECTION 15864N
Page 14
Previous Page
