NEMA ICS 6
(1993; R 2001) Industrial Control and
Systems: Enclosures
NEMA MG 1
(2003; R 2004) Motors and Generators
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
NFPA 70
(2005) National Electrical Code
NFPA 90A
(2002) Installation of Air Conditioning
and Ventilating Systems
SHEET METAL AND AIR CONDITIONING CONTRACTORS' NATIONAL ASSOCIATION
(SMACNA)
SMACNA HVAC Duct Const Stds
(1995, 2nd Ed) HVAC Duct Construction
Standards - Metal and Flexible
TECHNICAL ASSOCIATION OF THE PULP AND PAPER INDUSTRY (TAPPI)
TAPPI T403 OM
(2002) Bursting Strength of Paper
TAPPI T404 CM
(1992) Tensile Breaking Strength and
Elongation of Paper and Paperboard (Using
Pendulum-Type Tester)
TAPPI T410 OM
(2002) Grammage of Paper and Paperboard
(Weight Per Unit Area)
TAPPI T456 OM
(2003) Wet Tensile Breaking Strength of
Paper and Paperboard ("Wet Tensile
Strength")
TAPPI T487 PM
(1999) Fungus Resistance of Paper and
Paperboard
1.2
GENERAL REQUIREMENTS
Section 15050N BASIC MECHANICAL MATERIALS AND METHODS, with the following
additions and modifications. Provide water treatment and positive water
bleed-off for the evaporative cooling system. The color of finished coat,
lubrication, and treatment for fungus resistance shall be the
manufacturer's standard. Provide solenoid valves in water supply lines.
Furnish starting switch separated from coolers, integral with the
thermostat control. [Provide manual reset control for motors rated greater
than 3/4 kW one hp.] [Provide air filters for air inlets for rotary-type
evaporator coolers.]
1.3
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
SECTION 15721N
Page 5
Previous Page
