AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI Z21.49
(1992; A 1995) Gas-Fired Gravity and Fan
Type Vented Wall Furnaces
ANSI Z21.66
(1996) Automatic Vent Damper Devices for
Use with Gas-Fired Appliances
ANSI Z83.4
(1991; A 2002) Non-Circulating Direct
Gas-Fired Industrial Air Heaters
ANSI Z83.6
(1990; A 1993) Gas-Fired Infrared Heaters
ANSI Z83.8
(2002) Gas Unit Heaters and Gas-Fired Duct
Furnaces
CSA INTERNATIONAL (CSA)
CSA Directory
(updated continuously online) Certified
Products Listings
NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA)
NEMA MG 1
(2003; R 2004) Motors and Generators
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
NFPA 211
(2003) Chimneys, Fireplaces, Vents, and
Solid Fuel-Burning Appliances
NFPA 54
(2002) National Fuel Gas Code
UNDERWRITERS LABORATORIES (UL)
UL Gas&Oil Dir
and Gases Equipment Directory
1.2
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
should be required.
A "G" following a submittal item indicates that the
submittal requires Government approval. Some
submittals are already marked with a "G". Only
delete an existing "G" if the submittal item is not
complex and can be reviewed through the Contractor's
Quality Control system. Only add a "G" if the
submittal is sufficiently important or complex in
context of the project.
For submittals requiring Government approval on Army
projects, a code of up to three characters within
the submittal tags may be used following the "G"
designation to indicate the approving authority.
SECTION 15565A
Page 4
Previous Page
