shall have water supply assembly, exposed thermostatic mixing
valve with thermometer backflow preventer, 1524 mm 5 feet of
rubber hose, and wall hook. Waste fitting shall consist of 40.0
mm 1-1/2 inch pop-up waste and overflow with operating mechanism
at the top of fixture.
c.
Item P0330. Bath, sitz, vitreous china vitreous-glazed
earthenware shall be designed to be built into the wall at back;
shall have nominal overall dimensions 762.0 x 711.2 mm 30 x 28
inches with height of back 533.4 mm 21 inches and height of rim
355.6 to 406.4 mm 14 to 16 inches above floor; and shall have
water supply assembly, exposed thermostatic mixing valve with
thermometer, backflow preventer, 1524 mm 5 feet of rubber hose and
wall hook. Waste fitting shall consist of 40.0 mm 1-1/2 inch
pop-up waste and overflow with operating mechanism at the top of
fixture.
d.
Item P0500. Bathtub, corner, shall conform to ASME A112.19.1M
with pop-up drain, and with shower fixture. Shower shall be
complete with thermostatic or pressure balancing mixing valve.
Bathtub shall be enameled cast iron.
e.
Item P0700. Bathtub, recessed, 1524 mm 60 inches long, shall
conform to ASME A112.19.1M, Part A, Type I, Style A; with pop-up
drain, and with shower fixture. Shower shall be complete with
thermostatic or pressure balancing mixing valve. Bathtub shall be
enameled cast iron.
f.
Item P0750. Bathtub, recessed, shall conform to ASME A112.19.1M
with pop-up drain, and with shower fixture. Shower shall be
complete with thermostatic or pressure balancing mixing valve.
Bathtub shall be enameled cast iron.
g.
Item P1000. Bathtub, NP type, about 761.0 mm 30 incheswide, 1676
mm 66 inches long, 457.2 mm 18 inches high shall be installed with
the rim 609.6 mm 24 inches above the floor; shall be cast-iron
roll rim fixture, enameled inside and outside with acid-resisting
porcelain enamel or a vitreous glazed earthenware; shall be
designed for installation on a masonry or terrazzo base and for
tiling in at the waste end. Thermostatic mixing valve shall be
designed to deliver water at a rate of 37.8 L/min 10 gpm based on
a water pressure of 310 kPa 45 psi at a maximum temperature of 41
degrees C 105 degrees F.
h.
Item P1050. Bathtub, pier type for mounting on masonry base,
762.0 mm 30 inches wide, 1676 mm 66 inches long, 457.2 mm 18 inches
deep, with the rim 609.6 mm 24 inches, including base, above
floor. Each fixture shall be provided with a built-in at the end
fitting, a spray fitting, a backflow preventer, and a pop-up waste.
i.
Item P1100. Rinse valve, bedpan, for mounting on water closet
having exposed flush valve; provided with wall support bracket;
and brass valve body having a taper machined type leakproof, raise
and lower spray arm; and using one-third of flush water volume to
rinse pan, balance to flush waste.
j.
Item P1150. Rinse valve, bedpan, same as P1100, plus deodorant
disinfectant plastic disposal jar injection of approximately 30 mL
1 ounce solution with each flush.
SECTION 15405A
Page 31
Previous Page
