Flanged, Knife Gate Valves
MSS SP-88
(1993; R 2001) Diaphragm Valves
MSS SP-89
(1998) Pipe Hangers and Supports -
Fabrication and Installation Practices
NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA)
NEMA ICS 2
(2000; R
2004) Industrial Controls and
Systems:
Controllers, Contactors, and
Overload
Relays Rated Not More than 2000
Volts AC
or 750 Volts DC
NEMA ICS 6
(1993; R 2001) Industrial Control and
Systems: Enclosures
NEMA MG 1
(2003; R 2004) Motors and Generators
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
NFPA 50
(2001) Bulk Oxygen Systems at Consumer
Sites
NFPA 70
(2005) National Electrical Code
NFPA 99
(2005) Health Care Facilities
SHEET METAL AND AIR CONDITIONING CONTRACTORS' NATIONAL ASSOCIATION
(SMACNA)
SMACNA Seismic Restraint Mnl
(1998, 2nd Ed) Seismic Restraint Manual:
Guidelines for Mechanical Systems
THE SOCIETY FOR PROTECTIVE COATINGS (SSPC)
SSPC SP 6
(2000) Commercial Blast Cleaning
U.S. GENERAL SERVICES ADMINISTRATION (GSA)
FS A-A-1689
(Rev B) Tape, Pressure-Sensitive Adhesive,
(Plastic Film)
U.S. NATIONAL ARCHIVES AND RECORDS ADMINISTRATION (NARA)
29 CFR 1910.104
Oxygen
1.2
RELATED REQUIREMENTS
Section 15050N BASIC MECHANICAL MATERIALS ND METHODS, applies to this
section with the additions and modifications specified herein.
1.3
SUBMITTALS
**************************************************************************
NOTE: Submittals must be limited to those necessary
for adequate quality control. The importance of an
item in the project should be one of the primary
factors in determining if a submittal for the item
SECTION 15217N
Page 9
Previous Page
