**************************************************************************
USACE / NAVFAC / AFCESA
UFGS-15216N (September 1999)
------------------------------
Preparing Activity: NAVFAC
Replacing without revision
NFGS of same number and date
UNIFIED FACILITIES GUIDE SPECIFICATIONS
References are in agreement with UMRL dated 23 June 2005
**************************************************************************
SECTION 15216N
WELDING PRESSURE PIPING
09/99
**************************************************************************
NOTE: This guide specification covers the
requirements for welding of piping and piping system
components which will contain fluids under pressure
including hydraulic systems.
Comments and suggestions on this guide specification
are welcome and should be directed to the technical
proponent of the specification. A listing of
technical proponents, including their organization
designation and telephone number, is on the Internet.
Recommended changes to a UFGS should be submitted as
a Criteria Change Request (CCR).
Use of electronic communication is encouraged.
Brackets are used in the text to indicate designer
choices or locations where text must be supplied by
the designer.
**************************************************************************
**************************************************************************
NOTE: Piping materials, components, and supports
are specified in other sections of the project
specifications.
**************************************************************************
**************************************************************************
NOTE: The following information shall be shown on
1. Tensile strength, elongation, shear strength,
size, length, type, and location of the welds, as
necessary.
2. The project drawings should be checked to ensure
paragraphs has been shown and that there is no
conflict between the drawings and the
specifications. See also Note in paragraph entitled
"Definitions." The project drawings must indicate,
SECTION 15216N
Page 3