Recommended changes to a UFGS should be submitted as
a Criteria Change Request (CCR).
Use of electronic communication is encouraged.
Brackets are used in the text to indicate designer
choices or locations where text must be supplied by
the designer.
**************************************************************************
**************************************************************************
NOTE: TO DOWNLOAD UFGS GRAPHICS
Go to http://www.ccb.org/docs/ufgshome/graphtoc.pdf.
**************************************************************************
**************************************************************************
NOTE: The following information shall be shown on
the project drawings:
1.
Sketch NFGS-14637-1, including data.
2.
Runway track system.
3. Electrical junction box location (including
mounting height).
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to in the text by the
basic designation only.
AMERICAN INSTITUTE OF STEEL CONSTRUCTION (AISC)
AISC S329
(1985) Allowable Stress Design
Specification for Structural Joints Using
ASTM A 325 or A 490 Bolts
AMERICAN WELDING SOCIETY (AWS)
AWS D14.1
(1997) Welding Industrial and Mill Cranes
and Other Material Handling Equipment
ASME INTERNATIONAL (ASME)
ASME B1.1
(2001; R 2003) Unified Inch Screw Threads
(UN and UNR Thread Form)
ASME B18.2.2
(1987; R 1999) Square and Hex Nuts
ASME B30.10
(2000) Hooks
ASME B30.11
(1998) Monorails and Underhung Cranes
SECTION 14637N
Page 4
Previous Page
