PART 2
PRODUCTS
2.1
GENERAL
**************************************************************************
NOTE: For LANTNAVFACENGCOM use Class C only.
**************************************************************************
**************************************************************************
NOTE: Specify Class A Crane where precise handling
of valuable machinery and equipment at slow speeds
with long idle periods is required. Full capacity
loads may be handled for initial installation of
machinery and for infrequent maintenance.
Specify Class B Crane where service requirements are
light and speeds are slow. Loads may vary from no
load to full capacity, averaging 50 percent of full
capacity, with two to five lifts per hour. Not over
50 percent of the lifts will be at full capacity.
Specify Class C Crane where service requirements are
moderate. Loads may vary from no load to full
capacity, averaging 50 percent to full capacity,
with 5 to 10 lifts per hour. Not over 50 percent of
the loads will be at full capacity.
**************************************************************************
**************************************************************************
NOTE: A footwalk is recommended unless: the crane
can be safely serviced by another means; or where
lack of clearance would prohibit one.
**************************************************************************
Provide overhead electric traveling (OET) crane[s] conforming to CMAA 70,
Class C, for [indoor] [outdoor] service, ASME B30.2, and as specified
herein. [Provide a footwalk on the drive girder side.] The crane shall be
pendant controlled and operate in the spaces and within the loading
conditions indicated. The crane shall operate on [_____]-volts AC, 60 Hz,
[single] [three] phase power source. Maximum crane wheel loads (without
impact) due to dead and live loads, with the trolley in any position, shall
not cause a more severe loading condition in the runway support structure
than that produced by the design wheel loads and spacings indicated.
2.1.1
Capacity
The crane shall have a minimum rated capacity of [_____] metric tons tons
([_____] kg pounds). Mark the rated capacity in both kilogram and pound
units printed in different colors on both sides of the crane on the bridge
girders.
2.1.2
Speeds
**************************************************************************
NOTE: For LANTNAVFACENGCOM add bracketed sentence.
**************************************************************************
**************************************************************************
SECTION 14636N
Page 8