Go to http://www.ccb.org/docs/ufgshome/graphtoc.pdf.
**************************************************************************
**************************************************************************
NOTE: The following information shall be shown on
the project drawings:
1.
Sketch UFGS-14636-1, including data.
2.
Maximum span of runway girder.
3.
Runway rail size.
4.
Runway girder size.
5.
Channel cap size.
6. Size and location of crane stops.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
ASME INTERNATIONAL (ASME)
ASME B30.2
(2002) Overhead and Gantry Cranes (Top
Running Bridge, Single or Multiple Girder,
Top Running Trolley Hoist)
ASTM INTERNATIONAL (ASTM)
ASTM A 275/A 275M
(2003) Magnetic Particle Examination of
Steel Forgings
ASTM A 307
(2004) Carbon Steel Bolts and Studs, 60
000 PSI Tensile Strength
ASTM A 325
(2004b) Structural Bolts, Steel, Heat
Treated, 120/105 ksi Minimum Tensile
Strength
ASTM A 325M
(2004b) Structural Bolts, Steel, Heat
Treated, 830 Mpa Minimum Tensile Strength
(Metric)
SECTION 14636N
Page 4
Previous Page
