on the system.
4. Total calculated current draw of all devices
served by the existing standby battery under both
supervisory (standby) and alarm conditions.
5. Ampere-hour rating and type of existing battery.
**************************************************************************
PART 1
GENERAL
1.1
REFERENCES
**************************************************************************
NOTE: Issue (date) of references included in
project specifications need not be more current than
provided by the latest guide specification. Use of
SpecsIntact automated reference checking is
recommended for projects based on older guide
specifications.
**************************************************************************
The publications listed below form a part of this specification to the
extent referenced. The publications are referred to within the text by the
basic designation only.
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI C80.1
(1994) Rigid Steel Conduit - Zinc Coated
ASME INTERNATIONAL (ASME)
ASME A17.1
(2004) Handbook on Safety Code for
Elevators and Escalators
BUILDERS HARDWARE MANUFACTURERS ASSOCIATION (BHMA)
BHMA A156.15
(2001) Closer Holder Release Devices
FM GLOBAL (FM)
FM P7825
(2003) Approval Guide
INSTITUTE OF ELECTRICAL AND ELECTRONICS ENGINEERS (IEEE)
IEEE C62.41
(1991; R 1995) Recommended Practice for
Surge Voltages in Low-Voltage AC Power
Circuits
NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA)
NEMA C80.3
(1994) Electrical Metallic Tubing - Zinc
Coated (EMT)
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA)
NFPA 70
(2005) National Electrical Code
NFPA 72
(2002) National Fire Alarm Code
SECTION 13852N
Page 6
Previous Page
