Duct Tape

DETAIL SHEET 10. The glovebag assembly shall be 0.15 mm 6 mil thick

plastic, prefabricated and seamless at the bottom with preprinted OSHA

warning label.

1.23.2

Duct Tape

Industrial grade duct tape of appropriate widths suitable for bonding sheet

plastic and disposal container.

1.23.3

Disposal Containers

**************************************************************************

NOTE: Consult customer, federal, state, and local

requirements for the type of disposal container

allowed.

**************************************************************************

Leak-tight (defined as solids, liquids, or dust that cannot escape or spill

out) disposal containers shall be provided for ACM wastes as required by 29

CFR 1926.1101 and DETAIL SHEETS 9A, 9B, 9C and 14. Disposal containers can

be in the form of:

a.

Disposal Bags

b.

Fiberboard Drums

c.

Cardboard Boxes

1.23.4

Sheet Plastic

**************************************************************************

NOTE: Consult customer, federal, state and local

requirements. If necessary, specify the type of

sheet to be used and select the color and surface

treatment.

**************************************************************************

Sheet plastic shall be polyethylene of 0.15 mm 6 mil minimum thickness and

shall be provided in the largest sheet size necessary to minimize seams ,[as

indicated on the project drawings]. Film shall be [clear] [frosted] [or]

[black] and conform to ASTM D 4397, except as specified below:

1.23.4.1

Flame Resistant

Where a potential for fire exists, flame-resistant sheets shall be

provided. Film shall be [frosted] [or] [black] and shall conform to the

requirements of NFPA 701.

1.23.4.2

Reinforced

Reinforced sheets shall be provided where high skin strength is required,

such as where it constitutes the only barrier between the regulated area

and the outdoor environment. The sheet stock shall consist of translucent,

nylon-reinforced or woven-polyethylene thread laminated between 2 layers of

polyethylene film. Film shall meet flame resistant standards of NFPA 701.

1.23.5

Mastic Removing Solvent

Mastic removing solvent shall be nonflammable and shall not contain

SECTION 13280A

Page 30